Comnet 4 Port EOU Ethernet Extender - 4 x Network (RJ-45) - 5000 ft Extended Range - TAA Compliance CLRFE4POEU

The ComNet CopperLine® Ethernet over copper CL(L,R)FE(X)POE(C,U) Series supports up to sixteen channels of 10/100Mbps Ethernet with PoE+ Power Injection and Pass-through PoE+ over twisted pair cable (CAT-5, UTP) or over coax. With the ability to connect directly to a PoE+ switch, or the ability to generate PoE+ power with a 48 to 56 V input* to either the Local or Remote ends, these units provide the ultimate flexibility for extending a powered device (PD) over long distance copper. A complete set includes both a Local and Remote module. Remote units are available in small package sizes that include one or four channels, and Local modules are available in the same packages as well as a 1RU rack for larger channel counts. Features for CL(L,R)FE(X)POE(C,U) Series Full 10/100 Mbps Bandwidth Supports Multicast, Unicast and Jumbo Frame Symmetric Bandwidth provides consistent upload and download with virtually zero packet loss over the total usable distance Type tested to RFC-2544 TCP/IP network bandwidth packet transmission standards User-selectable data rate for maximum bandwidth and transmission distance utilization. Complies with all major IEEE standards and RFC network protocols for UDP, TCP/IP, HTTP/HTTPs Transmits individual Ethernet data channels with PoE+ Power Injection or Pass-through PoE+ over standard UTP or Coaxial cable Status indicating LEDs provide rapid indication of critical operating parameters. Extends Ethernet up to 3,000 feet (914 m) at 10 Mbps or 2,000 feet (610 m) at 100 Mbps over UTP cable Extends Ethernet up to 5,000 feet (1,524 m) at 10 Mbps or 2,000 feet (610 m) at 100 Mbps over Coaxial cable Extended Pass-through PoE meets the IEEE 802.3at standard for Power over Ethernet ComFit standard form factor is interchangeable between stand-alone or rack mount use. Tested and certified by an independent laboratory for full compliance with the environmental requirements (ambient operating temperature, mechanical shock, vibration, humidity with condensation, high-line/low-line voltage conditions and transient voltage protection) of NEMA TS-1/ TS-2 and the Caltrans Specification for Traffic Signal Control Equipment. Electrical ports support Auto-Negotiation for 10 Mbps or 100 Mbps, full duplex or half duplex data.